Ross Carbonite Series - Switcher Soft Reset; Factory Default Settings; To Factory Reset the Switcher; Resetting Individual Components

You can also press and hold MENU and press Reset
All (RESET on the C10/C1).
Factory Default Settings
You can restore the switcher to the factory default state.
All installation and personality settings are reset.
To Factory Reset the Switcher
1.
Press MENU > RESET > NEXT > NEXT > Factry
Reset.
2.
Press the Confrm knob to load the factory default
settings.
Resetting Individual Components
You can reset only the component that you want, instead
of the entire switcher. Individual MEs, keys, aux buses,
dissolves, wipes, and menu items can be reset.
Table 8: Resetting Individual Components
ResultButtons to PressTo Reset
all wipe parameters, including
position, pattern, and border, are
reset
WIPE and RESETWipes
all dissolve parameters are resetDISS and RESETDissolves
key parameters for key X including
clip, gain, and mask, are reset, but
KEY X SEL and
RESET
Keys
not key type, or chroma key color
selection (each keyer is reset
individually) (X is the number of the
key)
ME X parameters, including source
selections, are reset (each ME is
ME X and RESET
(C10/C1)
MEs
reset individually) (# is the number
of the ME)
ME X STORE and ME
X RECALL
(C1-A/C1M/C2/C2M/C2S/C2X)
STORE and RECALL
for the selected MEs
(C3S/C3X)
Aux bus X parameters, including
source selections, are reset (each
AUX X and RESETAux Buses
Aux is reset individually) (X is the
number of the aux bus)
the value for that knob is resetdouble-press the knob
for the value you want
to reset
Menu
Items
88 • Switcher Soft Reset — Carbonite Operation Manual (v13.0)