2. Kneading motor does not work
Kneadin
g motor
Tapping
motor
Kneadin
g motor
Tapping
motor
Troubleshooting
Picture 1 Picture 2
Analysis of causes： Method of exclusion:
1.Motor is damaged
2.Main board is damaged
3.Loose/broken connecting
cable
1.Use remote controller to power on chair, then select MANUAL mode---> SYNC
massage. Find the massage mech kneading motor plug (blue) and connect it to
tapping motor plug (red). If the kneading motor does NOT work, then replace a
new kneading motor, if it still works, then move to next step (might be main board
or cable problem).
2.Plug the motor back to its original position, again power on chair and select
SYNC massage. Find the mainboard kneading motor plug (blue) and connect it with
tapping motor plug (red). Check if the kneading motor works, if it works then
replace a new mainboard, if no, replace a new connecting cable (can use a multi-
meter to check the cable).
To Next Page
Loading...