INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 15 of 52
FAILURE TO OBSERVE THE ABOVE
INSTRUCTIONS WILL IMMEDIATE-
LY INVALIDATE THE WARRANTY.
10.1 Electrical checks
BEFORE STARTING UP THE
WHEEL-BALANCER, BE SURE TO
BECOME FAMILIAR WITH THE LO-
CATION AND OPERATION OF ALL
CONTROLS AND CHECK THEIR
PROPER OPERATION (SEE PAR.
“CONTROLS”).
CARRY OUT A DAILY CHECK OF
MAINTAINED-TYPE CONTROLS
CORRECT FUNCTIONING, BEFORE
STARTING MACHINE OPERATION.
Once the plug/socket connection has been made, turn
on the machine using the master switch (Fig. 8 ref. 1).
1
Fig. 8
11.0 MULTIFUNCTION LED PANEL
The wheel balancers are equipped with a multi-function
display panel with signal LEDs, together with a silk-
screen representing the shape of a rim and the various
available options.
This panel also includes LEDs indicating where the
operator shall fit adhesive or clip weights and the
balancing mode and/or option used, as well as correct
wheel rotation for inner/outer weights positioning.
Fig. 9
1 2 3 45
6 7 8
9
KEY
1 – Display screen “D1” showing INNER/DIMEN-
SIONS unbalance
2 – LED showing wheel rotation inner/outer
3 – Display screen “D2” showing OUTER/DIMEN-
SIONS unbalance
4 – Indication of the selected USER (see Par. 14.2)
5 – Selected program indication
6 – Rim shape diagram with weights position
7 – OPTION Weights hidden behind spokes (see
Chapter 17)
8 – MATCHING OPTION (see Chapter 18)
9 – SPLIT OPTION (see Chapter 16)
1297-M043-0
To Next Page
Loading...