GB
Page 18 of 52
INSTRUCTION, USE AND
MAINTENANCE MANUAL
13.0 SWITCHING THE MACHINE ON AND
OFF
The ON/OFF master switch is located on the rear of
the machine.
To start the machine and access the program, switch
on the system by turning the master switch.
Wait a few seconds for the operating program to load
and for the first program page to appear on the dis-
play screens D1 and D2: (flashing dashes
)
Use operative keyboard keys (see Fig. 9) to use all
machine available functions.
Key for balancing cycle start.
Key for stop / end procedure.
Key for data recalculation / confirma-
tion.
Key for wheel dimensions entry.
Keys to increase/decrease entered
values.
Key for MOTORCYCLE/CAR wheel
cycle.
Key for balancing program selection.
Key for Option selection.
Key for Eco-Weight procedure.
“Zoom” key for not rounded-off unbal-
ance displaying.
Key for U1-U2 user selection.
Unused key.
During program running, the different keys may have
meanings different from the previously described
ones. The following pages of this manual will supply
a detailed description of these keys.
In addition, some functions are achieved by pressing
a combination of several keys, that will be described
later on in this manual.
Usually, to go back and abort the procedure, press
.
1297-M043-0
To Next Page
Loading...