GB
Page 34 of 52
INSTRUCTION, USE AND
MAINTENANCE MANUAL
If necessary, press key again to select wheel IN-
NER side, the LEDs close to the inner display D1 will
turn on. The example below refers to the OUTER side.
Press keys / to confirm. The system will
display the dimension of the two weights to be fitted
on the wheel. Press keys / again to in-
crease or decrease the dimension of the weights in the
awareness that, the bigger the weights, the bigger the
distance will automatically be between them.
Fig. 46
Choose the weights
to be fitted and confirm
Choose the value of the weights to be fitted and press
key to confirm.
The LEDs close to the D2 display now indicate the
direction wheel shall be moved in to fit the FIRST
weight. Turn the wheel at the point indicated by the
LEDs, until the correct position has been reached to
correct the unbalance (see Par. 14.3.6).
When this position is reached, press the pedal brake
to stop the wheel, fit the FIRST weight.
Fig. 47
Leds showing positioning in correct
weight fitting point
Press key to confirm that the FIRST weight has
been fitted, the LEDs beside D2 display now indicate
the direction in which the wheel shall be moved to fit
the SECOND weight. Turn wheel at the point indicated
by the direction LEDs, press the pedal brake to stop
the wheel, and fit the SECOND weight.
The outer side operation has been completed, press
key twice to quit.
If you wish to repeat the procedure also on wheel IN-
NER side, select the SPLIT option, as shown above,
and perform the same operation on the other side of
the wheel, or simply fit the inner weight at 12 o’clock.
17.0 WEIGHTS HIDDEN BEHIND SPOKES
MODE
Adhesive correction weight positioning may not look at-
tractive on some types of rims. In this case, the "weights
hidden behind spokes" mode can be used. This splits
any correction weight on the outer side (see Fig. 23)
into two parts to be hidden behind the rim spokes. It
can be used in both ALU-S or Static modes.
Proceed with ALU-S or Static unbalance measurement
displaying by performing a standard wheel spin (see
Par. 14.3.4 or 14.3.5).
Once the unbalance values have been determined,
press the OPTIONS key . “Spokes” symbol LED
turns on (see Fig. 48).
Fig. 48
“SPOKES” function selected
Press key to confirm the performance of the
“weights hidden behind the spokes” mode.
The symbol “- - -“ will flash on the outer display
screen D2, and the beside LEDs will flash as well.
(see Fig. 49).
Move any spoke up to “12 o’ clock” (in many cases, the
position could already be behind or near one of the
spokes) and press key to confirm and continue.
Fig. 49
Symbol “- - -“ and LEDs are flashing.
Move a spoke up to “12 o’ clock” and confirm
A number corresponding to the number of spokes
of the wheel will be shown on display screen D2 (see
Fig. 50).
1297-M043-0
To Next Page
Loading...