GB
Page 20 of 57
INSTRUCTION, USE AND
MAINTENANCE MANUAL
12.0 CONTROL PANEL
The wheel balancers are equipped with a control panel
equipped with a keyboard to interact/operate the con-
trols presented in graphical form on the monitor.
On the monitor are displayed all the instructions for the
correct wheel balancing, for example indicating where
the operator shall fit adhesive or clip weights and the
balancing mode and/or option used, as well as correct
wheel rotation for inner/outer weights positioning.
1
9
7
2
3
4
5
6
8
Fig. 22
KEY
1 – Monitor
2 – Function push button (red)
3 – Function push button (yellow)
4 – Function push button (grey)
5 – Function push button (blue)
6 – Function push button (green)
7 – Previous page push button
8 – Next page/print push button
9 – Push button panel (keyboard with 7 keys)
13.0 WHEEL BALANCING
13.1 Switching the machine on and off
Press the "ON" switch (Fig. 17 ref. 1), located in the
rear part of the equipment.
Wait a few seconds until the complete loading of the op-
erational program. The equipment is ready to operate
when the main screen "Home" appears on the monitor.
ALL SCREEN PAGES LISTED IN
THE MANUAL, UNLESS OTHER-
WISE SPECIFIED, DISPLAY THE
MEASUREMENTS EXPRESSED IN
GRAMS.
Fig. 23
1 2 34A B C
KEY
A – Displaying operations/information area
B – Colour identification buttons to use
C – Function icons
1 – Programs and measurements acquisition but-
tons
2 – Wheel spin push button
3 – Go to next page
4 – User management (if enabled) (user manage-
ment is not enabled on machine delivery)
At the bottom of the main screen page and of each
screen page described below, there will be coloured
rectangles (Fig. 23 ref. B) located above function iden-
tification icons (Fig. 23 ref. C). These functions are
activated by pressing the appropriate coloured button
on the push-button panel (Fig. 22 ref. 9). Press the
button (Fig. 23 ref. 3) to display a second page where
you can access “Technical assistance” and “Run-out”
Menu (see Fig. 24).
1297-M008-8
To Next Page
Loading...