Rotary RWB355SB - Recalculation Function; Motorbike Mode Wheel Balancing

GB
Page 40 of 57
INSTRUCTION, USE AND
MAINTENANCE MANUAL
13.10 Recalculation function
After making a spin, the wheel automatically stops,
indicating the weight/s to be fitted and its/their position.
In case the operator does not want the type of wheel
balance proposed by the machine (program type,
weights size, etc ...), proceed with the re-calculation
of the wheel balancing without rerunning the spin of
the wheel.
To do this, proceed as described below:
- press the button
to return to the measures
detection/program selection page;
- select a new balancing program as indicated in Par.
13.2.2;
- take with the gauge arm the measures required by
the selected program;
- press button
to perform the re-calculation. The
monitor will display the weights and the positions in
which they will be applied.
If also in this case the operator should decide to fur-
ther modify the balancing program, it is sufficient to
proceed as described above without having to spin
the wheel.
When the result of the recalculation does not satisfy
the operator, it is recommended to do a spin of the
wheel to confirm the findings from the operation of
recalculation itself.
After the launch of the wheel, the machine, in addi-
tion to displaying the unbalance value, draw up au-
tomatically all the programs measurement fields that
are consistent with those measures that were taken
previously and at the same time erases all measures
which are not consistent.
13.11 Motorbike mode wheel balancing
By enabling “motorbike wheel balancing” function, the
wheel balancers can also balance motorbike wheels.
Before detecting the wheel sizes (see Par. 13.2.2), se-
lect motorcycle wheel balancing mode proceeding as
described below:
press button
and then button . On the
screen that appears, press the button
to switch
to programs and measurements acquisition selection
screen below.
Use the arrows or to select the wished
mode. At the end press push button
. The ma-
chine will be configured as follows to perform the
measurement in the desired mode and on the screen
will appear an indication showing the measures that
will be acquired.
The "motorcycle" mode automatically recalculates the
wheel distance measurement, increasing this by the
length of the optional extension GAR181 A1.
To fit the extension (Fig. 40 ref. 2), first press the
threaded ring nut (Fig. 40 ref. 1) in the hole provided
and then screw the plastic terminal (see Fig. 40).
THE EXTENSION WILL ONLY
HAVE TO BE SCREWED UP WHEN
BALANCING IS PERFORMED IN
"MOTORBIKE" MODE.
1297-M008-8