GB
Page 42 of 57
INSTRUCTION, USE AND
MAINTENANCE MANUAL
14.1 Options menu
Press the button (Fig. 41 ref. 1), to display the
screen pages to enable/disable options as shown below:
Press three times the button to go to the next
page of options.
To go back to the previous page of options, press two
times the button
.
To enable / disable individual functions simply high-
light the icon using the buttons
and/or
and press the button
.
Pressing the button may involve, besides, the
change in the unit of measure from "mm" to "inch" and
vice versa (where applicable) or access to a sub-screen
for values settings values (see Par. 14.1.1 or 14.1.2).
After you select/deselect the desired options, exit the
menu by pressing push button
.
These options will be automatically stored.
List of available options
Enable/disable the protection guard/
spin (enabled on machine delivery).
Enable/disable the distance/diameter
detection caliper (enabled on machine
delivery).
Enable/disable the display of static
threshold after each spin (enabled on
machine delivery).
It allows you to set the thresholds for
each of the balancing mode weights
(see Par. 14.1.1).
Enable/disable the pneumatic brake
after the spin (disabled on machine
delivery).
It allows you to change the unit of meas-
urement of the weights from ounces/
grams to grams and vice versa.
It allows you to enable/disable the
width function detected by GAR (ena-
bled when fitted as standard on the
machine).
Enable/disable the positioning of
weights at "6 o'clock" (enabled on ma-
chine delivery).
Enable/disable the lock function for
caliper arm in position (disabled on
machine delivery).
It allows you to change the unit of
measure of the distance of the weights
fitting point from mm to inches and
vice versa.
Enable/disable the led light (enabled if
mounted on the machine).
Enable/disable the functions of motor-
bike balancing (disabled on machine
delivery).
Enable/disable the encoder mounted
on the spin motor (disabled on ma-
chine delivery).
1297-M008-8
To Next Page
Loading...