Rotary RWB355SB - Lower Weight Limit

INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 43 of 57
It allows you to change the unit of
measurement of the rims width from
mm to inches and vice versa.
It allows you to set the size values of
weights (see Par. 14.1.2).
Enable/disable the RUN-OUT functions
(enabled on machine delivery).
Enable/disable machine print functions
(disabled on machine delivery).
It allows you to change the unit of meas-
urement of the rim diameter from mm
to inches and vice versa.
Enable/disable the function of weights
positioning laser (enabled on machine
delivery).
Enable/disable the repositioning of the
wheel at the end of the spin (enabled
on machine delivery).
Enable/disable user function (disabled
on machine delivery).
Enable/disable the function of weights
positioning laser wheel inner/outer side
at 12 hours (disabled by default).
14.1.1 Lower weight limit
Correction weight below a certain limit is normally
shown equal to zero. This limit can be set from 50 g
to 2 g (from 2.00 oz to 0.05 oz).
At the end of the spin however, by pressing the button
, the weight can be displayed with max resolution
of 1 g (0.05 oz), not considering the set lower limit.
LOWER LIMIT'S FACTORY SET-
TING FOR DYNAMIC WHEEL BAL-
ANCING MODE IS 5 g (0.25 oz).
THE LOWER LIMIT FOR ALL THE
OTHER MODES IS SET AT 7 g
(0.35 oz).
1
KEY
1 – Lower weight limit in the DYNAMIC program to
display "OK" (default value 5 g (0.25 oz))
2 – Lower weight limit in the ALU-STATIC program
to display "OK" (default value 7 g (0.35 oz))
3 – Weights display resolution (default value 5 g
(0.25 oz))
2
3
Default
values
Work range
g oz g oz
5 0.25 2 ÷ 50 0.05 ÷2.00
7 0.35 2 ÷ 50 0.05 ÷2.00
5 0.25 2 ÷ 50 0.05 ÷2.00
100 100
0 - 50 - 100
150 - 200
0 - 50 - 100
150 - 200
% %
- Press the push button to shift among the field
to modify.
- Press or to modify the highlighted value.
THE BLUE-COLOURED-VALUE
IS THE ACTIVE FIELD AND THE
MODIFIABLE ONE.
1297-M008-8