Rotary SM40-47 - Default Chapter; Table of Contents

3
Table of Contents
1. Introduction ................................................................5
1.1 About this operating manual ....................................5
1.2 Warning and information symbols ...........................5
1.3 Intended use ...........................................................7
1.4 Incorrect use, incorrect behavior ............................ 7
1.5 Internal accident, health and safety, and environme-
ntal information ........................................ 7
2. Safety ............................... .......................... ....8
2.1 Operators ..................................................................8
2.2 Basic safety requirements ........................................8
2.3 Permitted axle loads and weight distribution ........ 9
2.4 Ban on unauthorized modications or alterations ....10
2.5 Experts, competent persons ....................................10
2.6 Maintenance contractors, installation staff ...............10
2.7 Safety inspections by competent persons ...............11
3. The 4-Post Lift ...............................................12
3.1 Overview of parts .....................................................12
3.2 General workow .....................................................13
3.3 Work area, danger zones ........................................14
3.4 Safety mechanisms .................................................14
3.5 Control unit ........................................................18
4. Operation .......................................................19
4.1 Emergency stop ........................................................19
4.2 Switch the machine on .............................................19
4.3 Determine the vehicle data ......................................19
4.4 Driving on .................................................................20
4.5Lifting/lowering .................................................20
4.6 Drive off ...................................................................21
4.7 Switch the machine off .............................................21
5. Problems, causes, actions............................22
5.1 Troubleshooting by the operator ..............................22
5.2 Troubleshooting by authorized maintenance
contractors ................................................................... ....24
6. Authorized lowering .......................................27
6.1 Manually lowering the lift when there is a height
difference of > 50 mm .......................................................27
6.2 Leveling the rolling jacks ..........................................28
6.3 Emergency manual function .....................................28
7. Technical data .................................................30
8. Cleaning ...........................................................33
9. Maintenance and repair ..................................34
9.1 Qualication of maintenance and repair staff ...........34
9.2 Maintenance and repair safety regulations ............. .34
9.3 Maintenance work ...........................................35
9.4 Approved hydraulic oils ............................................38
9.5 Check, rell, change the hydraulic oil .......................39
9.6 Repair work (Repairs) ..............................................40
10.Transport, Storage ...................................43
10.1 Transport .................................................................43
10.2 Ofoading.................................................................43
10.3 Storage ....................................................................43
11.Assembly ........................................................44
11.1 Assembly safety instructions ................................. 44
11.2 Quick assembly instructions ................ ..................44
11.3 Site specications ...................................................45
11.4 Installation preparations ..........................................45
11.5 Prepare the runways ...............................................46
11.6 Prepare the cross beams ........................................46
11.7 Set up the cables ....................................................47
11.8 Fasten the runways to the cross beams .................47
11.9 Assemble the lift column .........................................48
11.10 Attach the latch bars and cables ...........................49
11.11 Attach the exible hose .........................................50
11.12 Assemble the hydraulics module ..........................50
11.13 Assemble the pneumatic compents.......................52