Rotary SM40-47 - Attach the Latch Bars and Cables

49
1. Insert the supplied threaded pins (2) from above
through the top plate of the lift column and attach
using 2 lock nuts (1) for each pin
2. Insert the threaded pin (2) from above into the
latch bar.
3. Adjust the latch bar (3) using the hex nuts (1) in
such a way that it lies in a circular recess on the
oor but does not make contact with the oor.
4. Tighten the hex nuts at top and bottom slightly,
but do not yet tighten them fully.
7. Fit the 4 lift columns onto the shims with
approved nuts and bolt locking devices. Select
the tightening torque according to the bolt
manufacturer’s specications. Also consider the
on-site conditions.
Risk of fatal injury if lift columns
are not secured properly. Lift or
load could topple or collapse.
Comply with the specied torque on each
bolt.
If this is not possible, repair the oor acc-
ording to specications ( → Chapter 11.3),
otherwise commissioning cannot be carried
out.
DANGER
38
3
1
1
Bottom of Slot
Fig. 11
2
4
5
6
For SM40-47-BMW :Slide on the lift column onto
the two crossbeam guides leaving a gap of 1
mm and align preciselywith a spirit level .
6
1
5
3
2
4
1
For SM40-47-BMW
11.10 Attach the latch bars and cables
Proceed as follows on all 4 lift columns.