Rotary SM65-51 - Permitted Axle Loads and Weight Distribution

9
Risk of injury through toppling of
the vehicle when incorrectly loaded.
Comply with the permitted load capacity as in
Fig. 1 and 2.
Comply with the permitted weight distribution
as in Fig. 1 and 2.
Comply with the approved distances between
pick-up points as in Fig. 3.
Figure 1: SM35/40/55LT (with lifting table)
SM40LT Load capacity
•
Main lift 4000 kg
•
Lifting table 3000 kg
Permitted weight distribution
•
Main lift front max. 2/3:
F1 = max. 2670 kg
back max.1/3:
F2 = max. 1330 kg
•
Lifting table front max. 3/5:
F1: 1800 kg
back max.2/5:
F2: 1200 kg
SM35/55LT Load capacity
•
Main lift 3500/5500 kg
•
Lifting table 3500 kg
Permitted weight distribution
•
Main lift 5500kg
front max. 2/3: F1 = max. 3670 kg
back max.1/3: F2 = max. 1830 kg
•
Main lift 3500kg
front max. 2/3: F1 = max. 2330 kg
back max.1/3: F2 = max. 1170 kg
•
Lifting table front max. 3/5:F1: 2100 kg
back max.2/5:F2: 1400 kg
Figure 2: SM40 /MOT40 or SM65/MOT65
Load capacity
•
SM40/MOT40 4000kg
•
SM65/MOT65 6500 kg
Permitted weight distribution
•
SM40 /MOT40 front max. 2/3:
FA1 = max. 2670 kg
back max.1/3:
FA2 = max. 1330 kg
•
SM65 /MOT65 front max. 2/3:
FA1 = max. 4330kg
back max.1/3:
FA2 = max. 2170 kg
Figure 3: Approved distance between pick-up
points on lifting table for SM40LT
•
Length max. 1.7 m
•
Width min. 1.2m
Figure 4: Approved distance between pick-up
points on lifting table for SM55LT
•
Length max. 2.1 m
•
Width min. 1.4 m
WARNING
↓ ↓
F1
F2
1
4
←
←
FA1 FA2
2
max 2.1m
min 1.4m
3