43
10.3 Storage
Lift components must always be stored in a dry
place (no corrosion protection).
Recommended Storage Conditions
•
Ambient temperature: -5 ... +50
•
Relative humidity, 30 % ... 95 %
with condensation, at 20 °C
The manufacturer provides no warranty for
corrosion damage caused by incorrect
storage.
10.2 Ofoading
1. Inspect the shipment for any shipping or transport
damage. Immediately report any damage to your
supervisor and to the transport rm.
2. If there is any transport damage, contact the
transport rm.
3. Transport the packing unit to the installation site.
This must conform to the approved environmental
conditions ( → Chapter 7. Technical data).
4. Unfasten the transport locks for the large parts on
the front of the packing unit.
5. Ofoad the runways and cross beams and set
down carefully.
Recommended: Raise the runways and cross
beams slightly, for example set down onto
stable wood beams. This will also enable
you to better route the pneumatic lines and
electrical cables later.
6. Remove all other components from the pallet
and set down carefully.
7. Inspect the supplied parts according to the
packing list provided.
8. Dispose of packaging in an environmentally
friendly manner, in compliance with the
regulations applicable in your country
( → Chapter 16. Disposal).
To Next Page
Loading...
