18
Use holes marked with arrow for Right Front
and Left Rear.
Use holes marked with arrow for Left Front
and Right Rear.
Fig. 17c
NOTE: Once arm is installed in yoke, pull up
actuator pin and swing arm fully around, being
sure that the Restraint Gear and Gear Block always
stay aligned. If they do not stay aligned, remove
restraint gear and install in the opposite position.
NOTE: To check operation of arm restraints, raise carriage
1” min. from full down position. Pull up on pin-ring and
adjust arms to desired position. To engage restraint, let
pin-ring down allowing gear teeth to mesh together. It may
be necessary to rotate arm slightly to engage gear teeth.
NOTE: Pin & Ring, Spring, & Gear Block are all
preassembled.
Fig. 18
Fig. 19
DO NOT use holes marked with arrows.
To Next Page
Loading...
