BRP-Rotax
INSTALLATION MANUAL
INSTALLATION AND CONNECTION
OF THE FUEL PUMP
Tools required:
• Allen key 5 mm
• Circlip pliers
Step
Procedure
1
The retaining plate, rubber buffers, fuel
pump, fuel hose (with 230 mm and
1800 mm length) is already pre-
assembled.
Figure 3.1
Step
Procedure
2
Install the retaining plate with fuel
pump (pos. 1) on the gearbox cover by
using 2 screws M6x30 (pos. 3) and
washers (pos. 2).
Figure 3.2
1
Fuel pump
2
Washer
3 Screws M6x30
Figure 3.3
TIP
Facilitate the assembly of fuel hose by
slightly widening the hose end with a pair
of circlip pliers.
ATTENTION
Fuel hose can be damaged!
Avoid excessive widening of the fuel hose.
2
Page 2
Edition: September 01 2019
Effectivity: 125 MAX DD2 evo
To Next Page
Loading...
