BRP-Rotax
INSTALLATION MANUAL
Step
Procedure
3
The fuel hose with 230 mm length will
be connected later to the carburetor,
see carburetor installation.
4
The larger fuel hose (pos. 1) should be
connected to the fuel filter (pos. 2) and
to the fuel tank.
Figure 3.4
1
Large fuel hose
2
Fuel filter
ATTENTION
Pay attention to the direction of the arrow on
the fuel filter.
This must point towards the fuel pump.
ATTENTION
Route the fuel line from the fuel tank to the fuel fil-
ter so that it does not touch any moving parts of
the track and attach the fuel line onto the top side
of the chassis tube.
ATTENTION
The flow in the impulse hose and fuel lines
must not be restricted by the use of cable ties.
Effectivity: 125 MAX DD2 evo
2
Page 3
Edition: September 01 2019
To Next Page
Loading...
