Rotax 125 MAX DD2 evo - Page 60

BRP-Rotax
INSTALLATION MANUAL
NOTE
For draining the oil from the gear case, remove
the magnetic oil drain plug (pos. 1) and sealing
ring (pos. 2). Clean the oil drain plug before in-
stallation. Always use a new sealing ring.
Figure 8.3
1
Magnetic oil drain
plug
2
Sealing ring
NOTE
Tighten magnetic oil drain plug (pos. 1) to 20
Nm (177 lbf.in.).
m WARNING
Non-compliance can result in serious injuries
or death!
Do not run the engine without gear oil. This will
lead to engine failure.
Effectivity: 125 MAX DD2 evo
7
Page 3
Edition: September 01 2019