Rotax 125 MAX DD2 evo - Page 98

BRP-Rotax
Operators Manual
Figure 3.13: Gear cover
Step
Procedure
4
Remove the primary drive gear (pos. 4) and secondary gear (pos. 5) and fit
the gear pair of your choice.
NOTE
At re-assembly, proceed in reverse sequence. Tighten the screws to
the following torque settings:
M6: 10 Nm (88 lbf. in.) / M8: 22 Nm (195 lbf. in.)
Figure 3.14: Gear ratio
Effectivity: 125 MAX DD2 evo
3
Page 17
Edition: September 01 2019