ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
8. Installation of the battery
See Fig. 27.
Warning: Make absolutely sure to avoid short-circuiting of battery terminals. A short
circuit will ruin the battery and could cause
an explosion.
The battery must be located on the left side box beside the
driver’s seat. For proper attachment a fixture kit for the
battery will be supplied with the engine by ROTAX.
Attach the battery fixture (pos. 5) with the two
pipe clamps (pos. 1 – 4) on the left side box
beside the driver’s seat.
Note: The clamps (pos. 2, 3) are designed for
chassis tubes of 30 - 32 mm (1.18 – 1.26 in)
dia.
Attention: Risk of clamp fracture! Do not over tighten the
screw (pos. 1) of the pipe clamps (pos. 2, 3).
Put the rubber pad (pos. 6) inside the battery
holder (pos. 5).
Put the battery (pos. 7) into the fixture and
install the cover (pos. 8) with pre-assembled
wiring harness using the Allen screw with
rounded flange head (pos. 9).
For connecting the battery refer to section 8.1.
TIP: The battery fixture (pos. 5) can be fixed with
one screw on one side of the clamp (pos. 3).
For different fixing alternatives, see Fig. 28.
Fig. 27
Fig. 28
Page 17/53
Edition 07/2016
To Next Page
Loading...
