Rotax 125 MAX evo - Page 98

ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
7. Engine start and operation
7.1. Engine start and operation
Prior to engine start, verify the following:
 Fuel tank full.
 Battery charged and connected.
 Battery voltage over 12.4 V
 Carburetor Bowden cable is moving freely and carburetor piston connected in idle
position.
At engine start proceed as follows:
 On a cold engine pull the choke lever (pos. 1, Fig. 5) into a vertical position.
Fig. 5
 Turn the combination switch to "START", the electric starter is activated. Hold the
switch in this position until the engine starts (Fig. 6).
 Note: If the engine does not start, repeat the operation after a few seconds in the same
manner.
 After engine start, take choke back slowly until engine idles smoothly without choke.
Fig. 6
 Warning: Always wear protective clothing for kart operation (helmet, overall, gloves,
shoes, neck and rib guards).
Page 45/53 Edition 07/2016