DK00027.fm
REPAIR MANUAL
BRP-Powertrain
Effectivity: 125 MAX/125 Junior MAX/125 Mini
MAX/125 Micro MAX
Edition 2 / Rev. 0
Chapter 5
Page 20
December 01/2010
3.3.3) Crankshaft out of run
General NOTES: If the out of run of the crankshaft exceeds the tolerance,
the crankshaft must be re-aligned.
Special tools The following special tools and equipment are required:
Instructions See Figure 12.
Graphic Aligning the crankshaft
Figure 12 K00092
Part number Description Use
Part no. 276050 Repair kit Crankshaft
n.e. Vise
Step Procedure
1 To align the crankshaft, clamp the drive end or engine end of the crankshaft
half (1) in a vise (2).
2 Press with lever (3) in the correct area.
3 The crankshaft can be aligned to the external diameter of the crankshaft webs
with target strokes of an aluminum hammer.
Part Function
1 Crankshaft half
2Vise
3 Lever
To Next Page
Loading...
