Effectivity: 912 Series
Edition 1 / Rev. 0
d04054
page 57
May 01/2007
BRP-Rotax
INSTALLATION MANUAL
- water inlet bend (5): outside dia. 27 mm (1 1/16")
slip-on length max. 19 mm (3/4")
◆ NOTE: Choose between six possible fitting positions of water inlet
bend (5) appropriate to specific installation (see Fig. 27).
The inlet bend is attached to the water pump by two Allen
screws M6x20 and lock washers. Tighten screws to 10 Nm (90
in.lb.).
■ CAUTION: Utilize total slip-on length for hose connection. Secure hoses
with suitable spring type clamp or screw clamp.
110°
105°
70°
75°
Fig. 28
Fig. 27
05536
00562
5
To Next Page
Loading...
