Rotax 912 ULS 3 - Connecting Dimensions and Location of Connections; 1) Oil Circuit (Engine)

page 72
May 01/2007
Effectivity: 912 Series
Edition 1 / Rev. 0
d04055
INSTALLATION MANUAL
BRP-Rotax
13.5) Connecting dimensions and location of connections
■ CAUTION: Utilize the full slip-on length for hose connections. Secure
hoses with suitable screw clamp or by crimp connection.
◆ NOTE: The oil pipeline connections are optional as UNF-thread (AN-
8). See SI-912-003.
13.5.1) Oil circuit (engine)
See Fig. 44, 45, 46 and 47.
Depending on engine certification, the oil pump inlet connectors can
vary:
- 912 A/F/S .. thread M18 - optional UNF-thread (AN-8)
- 912 UL/ULS inlet nipple - optional M18 or UNF-thread (AN-8)
Oil pump (inlet) (1) .................. thread M18 x 1,5 x 11
◆ NOTE: Suitable for use of a swivel joint. See Fig. 48.
Tightening torque of inlet line: .. 25 Nm (18.5 ft.lb)
Fig. 44
09123
1