Rotax 912 ULS 3 - 2) Oil Tank

Effectivity: 912 Series
Edition 1 / Rev. 0
d04055
page 75
May 01/2007
BRP-Rotax
INSTALLATION MANUAL
13.5.2) Oil tank
See Fig. 48 and 49.
The oil tank is furnished with 2 screw connections M18x1,5 and with
a tapped hole (M10x1).
Connections for oil circuit (engine)
- Oil inlet (6) and outlet (7) via standard swivel joint and connecting bend
(8):
2x connecting bend 90° (8)
outside dia. ............. 12 mm (.47 in.)
slip-on length ........... max. 24 mm (.94 in.)
tightening torque ...... 25 Nm (18.5 ft.lb)
- Oil inlet (6) and outlet (7) via standard UNF thread (AN-8) (optional):
thread ............. 3/4-16 UNF (AN-8)
Tightening torque of oil inlet and outlet: ............. 25 Nm (18.5 ft.lb)
■ CAUTION: The oil tank cap is additionally marked with the term
IN - oil inlet (6) from crank case
OUT - oil outlet (7) to oil cooler/oil tank. See Fig.
48.
1x venting nipple (9)
outside dia. ............. 8 mm (.31 in.)
slip-on length ........... max. 15 mm (.59 in.)
IN
OUT
8
7
9
6
ø165
90
248
ø139,2
Fig. 49
02469
Fig. 48
09124