00-00-00
page 28
October 01/2010
Effectivity 912/914 Series
Edition 1 / Rev. 3
d04774
BRP-Powertrain
Maintenance Manual
Dimensional check of parts
See Fig. 00-2
Take readings of all parts listed in the dimension sheets.
Enter the respective actual value in the dimension sheets attached directly after
each section.
■ CAUTION: Where measurement values are taken in hundredths of a
millimeter or more precisely, the temperature of the part must
be 20 to 25 °C (68 to 77 °F).
07437
Fig. 00-2
8.2) List of abbreviations
The following table shows the abbreviations used for the control points.
Abbreviations for control points
08216
Abbreviation Description
AL alternator
CA camshaft
CC crankcase
CH cylinder head
CR conrod
CS crankshaft
CY cylinder
EL electric
ES electric starter
EX exhaust
GB gearbox
GO governor
OP oil pump
PI piston
PP piston pin
ST stator
TC turbo charger
VT valve train
WP water pump
To Next Page
Loading...
