Rotax MMH-912 Series - 3.6) Bowden cable, rope sheave and spring for wastegate control (on the 914 Series); 3.6.1) Disassembly

78-00-00
page 20
July 01/2008
Effectivity 914 Series
Edition 1 / Rev. 2
d04356
BRP-Rotax
Maintenance Manual
3.6) Bowden cable, rope sheave and spring for wastegate control (on the 914
Series)
See Fig. 78-13
3.6.1) Disassembly
Remove tension spring (1) with a suitable tool and cut wire (2) of the
Bowden cable.
Loosen set screw of nipple (3) and pull Bowden cable out of the cable
retainer (4).
Do not lose the pressure spring (5) 5.5/1.2/16.9. Remove spring and
store in a safe place.
Remove cotter pin (6) and pin (7) from wastegate lever (8).
Now the Bowden cable can be pulled out from the conduit.
If required, remove rope sheave (9) after removal of the allen screw
(10) M5 x 20 along with lock washer and washer.
02618
7
Fig. 78-13
16
17
18
13
15
11
12
6
7
8
9
10
1
2
3
4
5
1
6
15
14
11