d02880.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
12-20-00
page 51
October 01/2009
11.4) Install oil filter
General note See Fig. 25.
Procedure To mount the oil filter the following steps are necessary:
Inspect all systems for correct function.
Graphic Install oil filter.
Fig. 25 08550
WARNUNG
NOTICE
After test run inspect tight fit of oil filter.
Step Procedure
1 Clean the contact surface (1) of the oil pump housing (2) with a clean cloth.
2 Apply thin film engine oil on the gasket (3) of the oil filter (4).
3 Install the oil filter on the engine.
4 Screw on oil filter until oil filter gasket is seated solidly.
5 Tighten oil filter with 3/4 turn (270°).
Part Function
1 Contact surface
2 Oil pump housing
3 Gasket
4 Oil filter
1
2
4
3
4
4
A
B
C
To Next Page
Loading...
