EasyManua.ls Logo

Rotax MML-912 - Procedure Notes

Rotax MML-912
170 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
d02874.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
05-00-00
page 5
October 01/2009
1.3) Procedure notes
General note
Ignition “OFF“
Ignition “ON“
At maintenance work which requires ignition “ON“ and battery connected,
take care of the following:
- Secure the propeller against unintentional turning by hand and
- secure and observe propeller zone
Handling of oper-
ating fluids
.
At maintenance of cooling-, lubricating and fuel system take care without
fail that no contamination, metal chips, foreign material and/or dirt enters
the system.
Disassembly At disassembly of the engine, mark the components as necessary to
avoid any mix-up. Take care of these marks, don’t ruin them.
WARNUNG
WARNING
Non-compliance can result in serious injuries or death!
When carrying out maintenance and service work, re-
spect without fail the safety regulations.
WARNUNG
WARNING
Non-compliance can result in serious injuries or death!
This precautionary measure serves to avoid any inju-
ries in case of an unintentional start of the engine.
Principally ensure the following at each maintenance
event
- Ignition “OFF“ and system grounded,
- Disconnect battery
and secure engine against unintentional operation.
WARNUNG
WARNING
Risk of electric shock!
The ignition is switched on, as long as the ground-ca-
ble (P lead) is not properly connected to ground.
WARNUNG
WARNING
Failure to comply with this instruction may cause se-
vere burns or scalding!
Hot engine parts!
Allways allow the engine to cool down to ambient tem-
perature before starting work.

Table of Contents

Related product manuals