Rotax MML-912 - Annual Inspection; Time Limit for Rubber Parts; Time Limit for the Coolant

d02875.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
05-10-00
page 8
October 01/2009
2.1) Time limit for rubber parts
General note
Time limit The following components and systems must be replaced every 5 years:
2.2) Time limit for the coolant
General note Coolant must be replaced as per manufacturers instructions, at the latest
during overhaul or when the engine is replaced.
2.3) Annual inspection
General note A 100 hr. inspection is to be carried out periodically after every 100 hours
of operation or every 12 months, whichever comes first.
See chap. 05-10-00 section: 2).

WARNUNG
NOTICE
This time limit must be followed independently and in
addition to the visual inspections (see chap. 05-20-00
section: 5.1)) of the respective components.
- venting hose of the carburetors
- all rubber hoses of the cooling system
- all rubber hoses of the fuel system (incl.
teflon hoses)
Fuel pump and insulating flange, if this is
fixed with fuel hoses.
- all rubber hoses of the lubrication sys-
tem which are part of the engine supply
volume and if they are not in the mainte-
nance schedule of aircraft manufacturer
- carburetor sockets
- connecting hose of the air intake system
- diaphragm on both carburetors
- rubber hoses on compensating tube
-V-belt