d02877.fm
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 912 Series
Edition 2 / Rev. 0
05-50-00
page 17
October 01/2009
3.7) Oil specification not respected
General note NOTES: An entry by the pilot in the engine log book of all pertinent
details is required.
If by error engine was serviced with oil, which does not correspond with
oil specification in the Operators Manual and the engine has been in
operation for less than 5 hours, the following measures must be taken:
less than 5 hr.
Graphic Position of the plug screw
Fig. 5 02712
Oil specification not respected
Step Procedure
1 Oil change.
2 Remove the lowest positioned banjo screw (1) (banjo bolt, plug screw or
screw socket) and drain the remaining oil from the crankcase. Screw in
banjo bolt or plug screw.
Tightening torque see Installation Manual 912 Series.
3 Replace oil filter.
4 Drain oil completely from oil cooler.
5 Drain oil from oil tank.
6 Refill oil tank with oil as specified, refer to Operators Manual.
7 Purge air from oil system. See chap. 12-20-00, section: 11.7).
8 Run engine for approx. 1 hour and replace oil and oil filter once more, as
stated above.
Part Function
1 plug screw
pos. 1
Zugpropeller
(tractor config.)
pos. 2
Druckpropeller
(pusher config.)
1
To Next Page
Loading...
