INFORMATION
2
CAPACITIES, FLUIDS AND LUBRICANTS
LUBRICATION
The engine and other lubricating systems are filled
with high-performance lubricants giving prolonged
life.
CAUTION: You should always use a high
quality oil of the correct viscosity range in
the engine and gearbox during
maintenance and when topping-up. The use of
oil not to the correct specification can lead to
high oil and fuel consumption and ultimately to
damaged components.
Oil to the correct specification contains additives
which disperse the corrosive acids formed by
combustion and prevent the formation of sludge
which can block the oil ways. Additional oil additives
should not be used.
Always adhere to the recommended servicing
intervals.
Engine/Gearbox oil
Use oil meeting specification ACEA A2 and having a
viscosity of 10W/30.
Gear linkage - Manual
Use a grease Part No. AFU 1500.1509 containing
3% Molybdenum Disulphide.
Steering rack
Use Sterak grease specification 31.815.252 in
accordance with specification 31.820.194; a toal
quantity of 100 cm
3
is required to fill a rack from the
dry condition.
General Greasing
Use Multipurpose Lithium Base Grease N.L.G.I.
consistency No. 2.
Bonnet latch
Lubricate cable and latch with oil.
Locks, latches and hinges
Use Door Lock and Latch Lubricant, Part No. VWN
10075.
To Next Page
Loading...
