FITTING THE BRUSHES AND REMO-
VING THEM FROM THE APPLIANCE
(B):
- Remove the protector
- Push the brush on until it clicks home.
- To remove: press button (B) and pull off the
brush.
GB
AIR TEMPERATURE / SPEED (C):
Air temperature / speed settings:
- Level 0: appliance off
- Level 1: moderate temperature and airflow
- Level 2: higher temperature and airflow
DIRECTION OF ROTATION (D):
This function enables you to automatically
wind the section of hair around the brush to
blow dry your hair effortlessly.
- To start rotation, press the selector switch (D) in
the desired direction of rotation (right or left).
- Keep pressing the switch while blow drying.
- To stop rotation, release the switch.
CLIC!
SPEED OF ROTATION (E):
Your appliance has a speed control for the brush rotation (E) - 13 positions -
to adjust it to suit your hair.
- To increase the speed, turn knob (E) to the right,
- to decrease it, turn knob (E) to the left.
HOW TO USE YOUR BRUSH:
This is the basic technique of blow drying.
DRYING AND STYLING IN ONE GO!
- After washing your hair, dry it well in a towel and carefully untangle it.
Do not use your brush on tangled or backcombed hair or on hair extensions.
- You can pre-dry your hair using the dryer function (C), position 2, (without brush) but leaving
your hair damp.
- Divide your hair into individual sections a few centimetres wide (see booklet "professional tips")
and work on one section at a time. You can use clips to hold up the other sections of hair.
- Fit the brush (large or small diameter, depending on the length of your hair and the desired
effect) to the body of the appliance, pushing it until it clicks home.
- Select the air temperature and flow rate (C): position 1 or 2 depending on your hair type.
- Choose the speed of rotation (E).
To Next Page
Loading...
Need help?
General
