Rowenta DR7000 User Manual

27
IS THERE A PROBLEM ?
PROBLEMS POSSIBLE CAUSES SOLUTIONS
There is no steam. The appliance is not plugged in,
or not switched on.
Check that your appliance
is correctly plugged in and
switched on.
The water level is too low. Unplug your appliance and rell it.
The steam pump has not been
primed.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
You are using the appliance for
the rst time.
Press the steam trigger continu-
ously for a few seconds to begin
steaming.
The water tank is not fully in
place.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
The appliance
does not heat.
It is not plugged in, or not
switched on.
Plug in your appliance and
switch on.
Water leaks. The water tank is not fully in
place or the stopper is not closed
properly.
Ensure that stopper is closed and
that the water tank snaps when
put into place.
Steam rate
decreases.
Calc Sealing. Refer to ‘ANTI CALC section in
instructions for use.
The steam leaves
stains on the fabric
or the appliance
spits.
You are using water with
additives.
Never add any additive in the
water tank.
The appliance has not been
cleaned enough after the
descaling operation.
Read carefully the ‘ANTI CALC’
section in instructions for use.
You are using other liquids than
white vinegar to descale the
product.
Use only white vinegar during
‘ANTI CALC’ procedure.
Appliance steams
continuously.
The steam trigger is on the lock
position.
Unlock the steam trigger.

Rowenta DR7000 Specifications

General

Brand	Rowenta
Model	DR7000
Category	Kitchen Appliances
Language	English