20
Troubleshooting QA
CONDITION REASON SOLUTION
There is no power
to the Juice Extractor
Juice Extractor will not operate if
parts are not assembled properly.
• Check if the power cord is properly plugged in.
• Check if the Hopper and the bowl are properly
assembled.
• Check to see if the Top-set and the Base are properly
assembled.
Low juice yield Each ingredient has different
amounts of liquid that will yield
different amounts of juice.
If the ingredients are not fresh,
they may contain reduced
amounts of fluid, which will
yield less juice.
• If the ingredient itself has low water content, it may
help to soak it in water before juicing.
• If juicing ingredients with small seeds, aer a few
servings, it may reduce the juice yield. For best
results, disassemble and wash the Top-set in
between juicing.
• If there is seed residue on the bottom of the
Strainer, this can affect Juice Extractor performance
and the overall juice yield.
There is too much pulp
in the juice
When continuously juicing, and
depending on the ingredient, the
juice may contain a lot
of fine pulp.
• To reduce the fine pulp, clean the
Top-set frequently and extract the pulp.
• Use a mesh strainer and put the juice through it to
collect the unwanted pulp.
• If the Strainer and the Ultrasqueezer are damaged
and affecting the Juice Extractor’s performance, it is
recommended the parts be replaced.
• The lifetime of each part may vary depending on
length and method of use and ingredients extracted.
To order parts, see customer service information
on page 24.
• If too many ingredients are inserted at the same
time, it may cause the Juice Extractor to stop
frequently. This can lead to pulpy juice. Insert the
ingredients slowly.
ROYAL PRESTIGE®
JUICE EXTRACTOR
To Next Page
