Royal Prestige JUICE EXTRACTOR - Fiber Management and Plastic Care

22
CONDITION REASON SOLUTION
During juicing,
the Juice Extractor
stopped
If too many ingredients are
inserted at one time, this can
cause the Juice Extractor to stop.
The Juice Extractor stops due to
the overload protection.
Hard seeds can damage
the Juice Extractor.
• Check the power cord and make sure it is
plugged in correctly.
• Check that all the parts are correctly assembled.
• Press the REVERSE - OFF - FORWARD button in this
order, switching back and forth 2 to 3 times.
• The REVERSE setting will push the ingredients
up, and the FORWARD setting will pull the
ingredients down.
• Let it cool for 30 minutes to 2 hours before
juicing again.
• If there are hard seeds within the ingredients,
remove them before juicing.
The Hopper is stuck If there is too much pulp in
the top-set, this can cause the
Hopper to not open.
• Aer juicing, let the Juice Extractor operate for
another 30 seconds to extract the remaining pulp.
• In this situation, press the REVERSE OFF - FORWARD
button in this order, switching back and forth
2 to 3 times.
• Pour water down the Hopper to rinse out the inside
and then try opening it.
Fibers are
wrapping around the
Ultrasqueezer and are
affecting performance
Ingredients with tough, long
fibers are more difficult to juice.
• When juicing fibrous ingredients, do not collect
more than 0.5 liter (approx. 2 ¼ cups) of juice. Aer
collecting this quantity or less, clean the top-set
completely before juicing again.
ROYAL PRESTIGE®
JUICE EXTRACTOR