ARP-1008 / ARP-1010
C. Install the Window Slider Kit : Fig 3.
1. Op en the window and place the Window Slider Kit on the inside edge of the window.
2. Adjust the Window Slider by adjusting it to the width of the window.
3. Close the window to secure.
4. Tighten the two screws to lock the window slider in palce.
D. Connecting the Exhaust Hose to the PAC : Fig 4.
1. Co n nect the hose connector to the air outlet by aligning the tabs on the hose to the PAC and snap it into place.
E. Connect the Exhaust Hose to Window Slider Kit : Fig 5.
1. Move the Portable Air Conditioner within 4 feet of the window.
Fig 3.
Fig 4.
Fig 5.
7
To Next Page
Loading...
