Need help?Do you have a question about the RR Electronic BISCAYA AIS and is the answer not in the manual?
General| Polarization | Vertical |
|---|---|
| Operating Temperature | -30°C to +70°C |
| VSWR | ≤1.5:1 |
| Impedance | 50 Ohm |
| Material | Fiberglass |
The antenna system should be mounted at the mast-head. No other antennas should be mounted above it.
Use 50 Ohm coaxial cables. Connect DELTA 200 S with BNC and DELTA 22 M with N-plug. Keep plugs strain-relieved.
Pull antenna cables through the holder and DELTA 22 M, connect to DELTA 200 S, then connect DELTA 22 M.
Connect antenna cable to AV 205 input, VHF radio to UKW terminal. Do not connect instruments to ground.
Connect DELTA 22 M cable to AV 403 input. Connect AIS Receiver to output.
Do not switch on power before installation is complete. Connect power to AV 205 before instruments are switched on.
Insert plug-in modules into AV 205 sockets with the 3-pin end at the output side.
TV reception may be affected by surroundings. Antennas, boxes, modules repaired by specialists only.
Check power supply, voltage, polarity, and antenna cable connections at mastbottom.
Check cable installation, indicator lamp, and for breaks or short circuits in antenna cable.
Verify plug-in module insertion, trimmer potentiometer setting, and cable connections for shorts.
Check AV 403 power supply, fuse, connectors, cables, and antenna cable resistance.
To Next Page
