5. Run Lock Controller
Parameter to be Specified Required Yes/No and Operational Parameter Comment
Outputs:
Run Lock Output 1 (with Diode)
Run Lock Output 2 (with Diode)
Run Lock Output 3 (without Diode)
Software Assigned Inputs:
Enable Inputs:
From Handset (Usually On/Off) Control
From Handbrake
From High Signal Inputs
From Low Signal Inputs
Inputs Assigned in Software:
Reset Inputs:
From Brake Lights
From Foot Brake
From Clutch
From Remote Button
From High Level Input
From Low level Input
Inputs Assigned in Software:
4. Split Charge Controller
Parameter to be Specified Required Yes/No and Operational Parameter Comment
Switch-In Secondary Battery Level
Switch-In Charge Secondary Battery Level
Monitoring of Primary Battery Voltage
Output to Drive Charging Solenoid
Solenoid Pull-In Voltage Level
Solenoid Drop-Out Voltage Level
RSG Engineering Limited Telephone : 01543 438800 Fax : 01543 438801 Email : sales@rsg-ontop.com Web : www.rsg-ontop.com
1:28
UNIVERSAL CONTROLLER PLUS (MCS-32) USER GUIDE V3 K : PROGRAMMING THE UNIVERSAL CONTROLLER PLUS
K:2 Allocation of Operational Parameters continued
K : Programming the Universal Controller Plus (MCS-32)
To Next Page
Loading...