Label and enable the system handset and then configure the device as shown in the example below.
Label and Enable
Configure
Following are the initial steps to set-up the MCS-32 and the corresponding handsets, leading on to a typical
most complex function. However, as options are so vast and varied we recommend one of our training courses
is attended.
RSG Engineering Limited Telephone : 01543 438800 Fax : 01543 438801 Email : sales@rsg-ontop.com Web : www.rsg-ontop.com
1:31
UNIVERSAL CONTROLLER PLUS (MCS-32) USER GUIDE V3 K : PROGRAMMING THE UNIVERSAL CONTROLLER PLUS
K:4 User Interface - Handset Type
K : Programming the Universal Controller Plus (MCS-32)
To Next Page
Loading...