transport keys to work but you can select a
printout during this cycle.
This is the normal display during the AUTO
reverse mode when defect inspection is actually
occuring. To see individual channel defect
counts, press the DISPLAY key.
OTHER DEFECT DISPLAYS ARE
DESCRIBED IN THE OPERATOR'S
MANUAL...
__________________________________
ERROR MESSAGES
This (along with the beeper) warns the operator
that at least one of the tissue rolls has been
exhausted. The machine will complete the
current run of tape but will not allow another
tape to be run until the new tissue roll has been
loaded. See inside cabinet lid for directions.
UP CEN LOW TOT
12 09 11 012
DEFECTS LENGTH
013 26:34
This display shows the defect counts in
individual channels. The operator may switch
back to the Total Defects/Length display at any
time during the rewind cycle or after the tape
has been ejected.
_____________________________________
This message warns the operator that the
cassette erase protect tab has been pushed in.
The machine will go into the AUTO mode but
will not erase the tape. Under these circum-
stances, this display is seen during the forward
AUTO mode until the machine starts to rewind
the tape.
**WARNING TAPE**
ERASE PROTECTED
***TISSUE LOW***
CHANGE ROLL
12
To Next Page
Loading...