Auto standby
● Your RS1 Sub has an automatic standby
function and is designed to be always
connected to a mains AC outlet.
● When there is no audio signal, your RS1 Sub
will remain in a low power standby state and
only turn on when it detects an audio input.
● After about 20 mins of no audio, your RS1 Sub
will go back to low power standby.
Overload protection
● Your RS1 Sub has a sophisticated soft-clipping
feature to prevent distortion and thermal
overload at high listening levels.
● In the unlikely event that it overheats, both
status LEDs will ash, and it will cut the audio
output until the internal temperature has
stabilised. This normally takes a few minutes.
To Next Page