Read Me First (625-0531-010)
GS-2108C Packing List :
Before you start installing GS-2108C Managed Switch, please verify that the package
contains the following items:
8 Port Gigabit L2 Managed Switch
AC Power Cord
User’s Guide CD-ROM
RS-232 Null Modem Cable
Please notify your sales representative immediately if any of the aforementioned items is
missing or damaged.
Power Requirements : AC Line
Voltage
: 100∼240 VAC
Frequency
: 50∼60 Hz
Consumption : 13W
Quick Installation :
1. Install the switch in the rack with mounting accessory.
2. Connect the GS-2108C switch to an AC power source.
3. The port 1–8 connector is RJ-45 jack on the switch. Use Category 5 UTP cable to
connect between GS-2108C and end station.
4. The port 7, 8 includes two types of media --- TP and SFP fiber module; they support TP
or fiber with auto-detected function.
5. Use RS-232 interface to pre-configure GS-2108C for network management.
For example: IP address, VLAN, Port Trunking, STP, etc.
GS-2108C switch’s serial port default settings are listed as follows:
Baud rate 57600
Stop bits 1
Data bits 8
Parity N
Flow control none
The default values of GS-2108C switch are as follows:
IP Address : 192.168.1.1
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.254
Username : admin
Password : admin
User also can use telnet or web to pre-configure GS-2108C with the default IP address
and username/password in the first configuration. Please refer to User’s Guide contained
in CD-ROM for details on the setting of parameters. GS-2108C user’s manual is filed
under the path: \manual of the CD-ROM.
Ruby Tech Corp.
2F, No.7, Lane 50, Nan Kang Road, Sec. 3, Taipei, Taiwan
Email: rubytech@mail.rubytech.com.tw
TEL: 886-2-2785-3961 FAX: 886-2-2786-3012
© 2005 Copyright by Ruby Tech Corporation and all rights reserved.
To Next Page
Loading...
Need help?
General
