S2600E/P CLI Reference Guide Chapter 2 Switch Management Configuration
Commands
Command Description
Related
commands
clock set
Set the system clock.
2.3.3 show line
To show the configuration of a line, execute the show line command in the
privileged mode.
show line {console line-num | vty line-num | line-num}
Parameter Description
console
Show the configuration of a console
line.
vty
Show the configuration of a vty line.
Parameter
description
line-num Number of the line
Command
mode
Privileged mode.
Usage
guidelines
This command shows the configuration information of a line.
Examples
The following example shows the configuration of console port:
Ruijie# show line console 0
CON Type speed Overruns
* 0 CON 9600 45927
Line 0, Location: "", Type: "vt100"
Length: 24 lines, Width: 79 columns
Special Chars: Escape Disconnect Activation
^^x none ^M
Timeouts: Idle EXEC Idle Session
never never
History is enabled, history size is 10.
Total input: 53564 bytes
Total output: 395756 bytes
Data overflow: 27697 bytes
stop rx interrupt: 0 times
2.3.4 show reload
To show the restart settings of the system, execute the show reload command
in the privileged EXEC mode.
show reload
To Next Page
Loading...