Ruijie RG-NBS3200 Series Switches Hardware Installation and Reference Guide Preparation Before Installation
23
action current of the leakage protector/2/maximum leakage current of each power supply = 30/2/1.5 = 10). In other
words, the leakage protector with 30 mA rated action current supports no more than ten power supplies. In this
case, the twenty power supplies in the system require at least two leakage protectors with 30 mA rated action
current and each leakage protector supports ten power supplies. If power supplies in a system differ in models, the
rated leakage action current of each leakage protector divided by two is greater than the sum of maximum leakage
current of all the power supplies. The rated leakage non-action current of a leakage protector must be 50% of the
leakage action current. The leakage protector with 30 mA rated leakage action current is used as an example. The
rated leakage non-action current must be 15 mA. When the leakage current falls below 15 mA, the protector
should not act. Otherwise, misoperation may easily occur due to high sensitivity and thus the leakage protector
trips, devices are powered off, and services are interrupted.
To guarantee personal safety, the rated leakage action current of each leakage protector in the system must be
equal to or less than 30 mA (human body safety current is 30 mA). When twice of the total leakage current of the
system is greater than 30 mA, the system must be equipped with two or more leakage protectors.
For details of the leakage current value of each power supply model, see Chapter 1 Product Overview.
2.1.4 ESD
To prevent Electronic Static Discharge (ESD), pay attention to the following points:
Proper grounding of grounding screws on the back panel of the device, and three-wire single-phase socket with
protective earth wire (PE) used as the AC power socket.
Indoor dust prevention
Proper humidity conditions
2.1.5 Laser
The RG-NBS3200 series switches support varying models of optical modules (Class I laser products) sold on the
market. Improper use of optical modules may cause damage. Therefore, pay attention to the following points:
When a fiber transceiver works, ensure that the port has been connected to an optical fiber or is covered with a
dust cap, to keep out dust and avoid burning your eyes.
When the optical module is working, do not pull out the fiber cable or look directly into the transceiver. The
transceiver emits laser light that may hurt your eyes.
Do not stare into any optical port under any circumstances because this may cause permanent damage
to your eyes.
2.1.6 Battery
The RG-NBS3200 series switches support the button cell battery. Improper use of battery may cause damage.
Therefore, pay attention to the following points:
There is the potential risk of fire or explosion or device damage if the battery of an incorrect type is
replaced. Replace the battery only with the same type.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, can result in
an explosion.
To Next Page
Loading...
