Ruijie RG-S2600G-I Series - Page 553

CLI Reference IGMP Snooping Configuration Commands
If the IGMP querier function is disabled globally, the
IGMP querier will be disabled in all VLANs.
Examples
The following example enables the IGMP querier for
the VLAN on the device:
Ruijie(config)# ip igmp snooping vlan 2 querier
Related
commands
Command
Description
ip igmp snooping
querier
Globally enable the
querier
Platform
description
Supported after release 10.4(3).
ip igmp snooping vlan querier address
To enable the IGMP querier, you also need to specify a source IP address for query
packets in the corresponding VLAN. Execute the global configuration command of "ip igmp
snooping vlan querier address". Use no form of this command to remove the source IP
address configured.
ip igmp snooping vlan vid querier address a.b.c.d
no ip igmp snooping vlan vid querier address
Parameter
description
Parameter
Description
vid
VLAN ID
a.b.c.d
Source IP address of
queries
Default
No source IP address is specified
Command
mode
Global configuration mode.
Usage
guidelines
After enabling the IGMP querier, you also need to
configure a source IP address for query packets, so
that the device can send packets normally.
If no source IP address is specified in the VLAN
needing to send packets, the device will verify
whether the source IP address is specified globally.
The device can only send query packets after finding
the source IP configured, or else the querier function
won't take effect.
If IGMP querier source IP has been specified in