Ruijie RG-S2600G-I Series - Page 554

CLI Reference IGMP Snooping Configuration Commands
VLAN, the source IP configured in the relevant
VLAN will be used first.
Examples
The following example specifies the source IP of
query packets in the specific VLAN on the device:
Ruijie(config)# ip igmp snooping vlan 3 querier
address 1.1.1.1
Related
commands
Command
Description
ip igmp snooping
querier address
Globally enable the
source IP check
Platform
description
Supported after release 10.4(3).
ip igmp snooping vlan querier max-response-time
To configure the maximum response time advertised in query packets of a specific VLAN,
execute the global configuration command of "ip igmp snooping vlan querier
max-response-time". Use no form of this command to restore to the default value.
ip igmp snooping vlan vid querier max-response-time num
no ip igmp snooping vlan vid querier max-response-time
Parameter
description
Parameter
Description
vid
VLAN ID
num
Maximum response
time (1-25); unit:
second; default: 10
Default
Default value
Command
mode
Global configuration mode.
Usage
guidelines
Configure this command to specify the maximum
response time to query packets of the specific
VLAN.
By default, the maximum response time is 10
seconds. If the maximum response time has been
specified in the corresponding VLAN, the value
specified in VLAN will be used first.
Examples
The following example specifies the maximum