Ruijie RG-S2600G-I Series - Page 555

CLI Reference IGMP Snooping Configuration Commands
response time advertised in query packets of a
specific VLAN:
Ruijie(config)# ip igmp snooping vlan 3 querier
max-response-time 15
Related
commands
Command
Description
ip igmp snooping
querier
max-response-time
Globally configure the
maximum response
time to query packets.
Platform
description
Supported after release 10.4(3).
ip igmp snooping vlan querier query-interval
To specify the interval for IGMP querier to send query packets of a specific VLAN,
execute the global configuration command of "ip igmp snooping vlan querier query-interval".
Use no form of this command to restore the query interval to the default value.
ip igmp snooping vlan vid querier query-interval num
no ip igmp snooping vid querier query-interval
Parameter
description
Parameter
Description
vid
VLAN ID
num
Query interval
(1-18000); unit: second;
default: 60 seconds
Default
Default value
Command
mode
Global configuration mode.
Usage
guidelines
After globally enabling IGMP querier, the timer will
be enabled for sending query packets periodically.
The aging time of the timer is the query interval.
Configure this command to change the query
interval.
If query interval has been configured in the
corresponding VLAN, the value specified in VLAN
will be used first.
Examples
The following example configures the query interval
for specific VLAN on the device: