Ruijie RG-S2600G-I Series - Page 556

CLI Reference IGMP Snooping Configuration Commands
Ruijie(config)# ip igmp snooping vlan 3 querier
query-interval 100
Related
commands
Command
Description
ip igmp snooping
querier query-interval
Globally configure the
query interval
Platform
description
Supported after release 10.4(3).
ip igmp snooping vlan querier timer expiry
To specify the expiration timer for non-querier, execute the global configuration command
of "ip igmp snooping vlan querier timer expiry". Use no form of this command to restore to
the default value.
ip igmp snooping vlan vid querier timer expiry num
no ip igmp snooping vlan vid querier timer expiry
Parameter
description
Parameter
Description
vid
VLAN ID
num
Non-querier expiration
timer (60-300); unit:
second; default: 125
seconds
Default
Default value
Command
mode
Global configuration mode.
Usage
guidelines
After globally enabling the IGMP querier, if the
device is elected as a non-querier, execute this
command to change the expiration timer for
non-querier.
If expiration timer has been configured in the
corresponding VLAN, the value specified in VLAN
will be used first.
Examples
The following example configures the non-querier
expiration timer for a specific VLAN:
Ruijie(config)# ip igmp snooping vlan 3 querier
timer expiry 60