Ruijie RG-S2600G-I Series - Page 815

CLI Reference NFPP Configuration Commands
Default
Settings
The default isolate time is 0, which means no isolation.
Command
mode
NFPP configuration mode.
Usage
guidelines
The isolate period can be configured globally or based on
the interface. For one interface, if the isolate period is not
set based on the interface, the global value shall be
adopted; or the interface-based isolate period shall be
adopted.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard isolate-period 180
Related
commands
Command
Description
nfpp dhcp-guard
isolate-period
Set the isolate time on the
interface.
show nfpp
dhcp-guard summary
Show the configurations.
dhcp-guard monitor-period
Use this command to configure the monitor time.
dhcp-guard monitor-period seconds
Parameter
description
Parameter
Description
seconds
Set the monitor time, in seconds. The
valid range is [180, 86400].
Default
Settings
600s
Command
mode
NFPP configuration mode.
Usage
guidelines
 When the attacker is detected, if the isolate period is
0, the attacker will be monitored by the software and
the timeout time will be the monitor period. During the
software monitoring, if the isolate period is not 0, the