Ruijie RG-S2600G-I Series - Page 816

CLI Reference NFPP Configuration Commands
software-monitored attacker will be auto-isolated by
the hardware and the timeout time will be the isolate
period. The monitor period is valid with the isolate
period 0.
 If the isolate period has changed to be 0, the
attackers on the interface will be removed rather than
being monitored by the software.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard monitor-period 180
Related
commands
Command
Description
show nfpp
dhcp-guard summary
Show the configurations.

show nfpp
dhcp-guard hosts
Show the monitored host list.

clear nfpp dhcp-guard
hosts
Clear the isolated host.
dhcp-guard monitored-host-limit
Use this command to set the maxmum monitored host number.
dhcp-guard monitored-host-limit number
Parameter
description
Parameter
Description
number
The maximum monitored host
number. The valid range is
1-4294967295.
Default
Settings
1000
Command
mode
NFPP configuration mode
Usage
guidelines
If the monitored host number has reached the default
1000, the administrator shall set the max-number smaller
than 1000 and it will prompt the message that %ERROR:The
value that you configured is smaller than current
monitored hosts 1000, please clear a part of monitored
hosts. to remind the administrator of the invalid